I bought the Velleman K8200 3D Printer back in 2014 for tinkering and getting my feet wet into the 3D printing world. Since then I learned lots about 3D printing, specificially construction, firmware, and its electronics. Now, the K8200 works, but not consistent as I would like it to be. Since I’m looking to start the Teardrop Trailer soon, I decided I wanted a 3D printer to just work. Set a print, and let it run. So, this is the start of the Ender 3 V2.

Latest Edits

Showing last edited date

Ender 3 Pro 3D Printer Posts

Showing all previous posts in section

  • Mar 14, 2022 Initial Upgrades
    Track of things I’ve added to the Ender 3 V2 to make it work the way I want it to work. Firmware # Upgraded to this firmware. GitHub - Jyers/Marlin: Marlin is an optimized firmware for RepRap 3D printers based on the Arduino platform. | Many commercial 3D printers come with Marlin installed. Check with your vendor if you need source code for your specific machine. Used UBL with BL Touch 10x10 Added Octopi # Allow for remote monitor could use Octopi to be the ‘host’ and send instruction, but were gonna use it for remote monitoring fixed under voltages with electrical tape - The neverending undervoltage error: octoprint decided on klipper and mailsail instead better fan?
comments powered by Disqus